*Must have IPC620 Experience*
The Source Inspector (SI) is responsible for performing inspection operations of in‐process or completed hardware, including dimensional and visual inspection.
Source inspection may include reviewing all paperwork related to the product, final inspection, receiving inspection, outside processing, and assembly.
The SI verifies FAI's against AS**** for accuracy and completeness, uses hand tools and gaging techniques, and interprets B/P and GD&T.;
Inspectures occur at end‐customer suppliers' locations, requiring travel.
Job Responsibilities
Dimensional inspection of aerospace machined components
Perform FAI's – AS****
Use hand measurement tools
Apply knowledge of CMM inspection process
Utilize GD&T; (ASME Y14.5) and blueprint interpretation
Conduct final and receiving inspections (dimensional, visual, surface finish, and assembly)
Read, interpret, and apply quality policies, procedures, and documents
Process warehouse materials
Follow established guidelines and procedures
Support corrective actions and root‐cause identification
Perform additional duties as assigned
Required Skills
Experience with dimensional inspection of aerospace machined components
Experience conducting FAI's – AS****
Proficient with hand measurement gages and conventional inspection techniques
Knowledge of GD&T; and blueprint interpretation
MS Outlook and Excel proficiency
Valid driver's license and auto insurance
Additional Desired Skills
Practical experience with quality inspection tools and equipment
Experience in RCCA and problem solving
General Requirements
Ability to handle complex situations and solve problems
Grace under pressure to meet deadlines
Technical and business information analysis
Strong teamwork and communication (verbal and written,



including telephone and email)
Ability to remain seated for up to 5 hours
Fluent in English (reading and writing)
Professionalism, integrity, and exceptional attention to detail
Independent decision‐making, analytical skills, and professional judgment
Interpersonal, written, and verbal communication excellence
Ability to manage several objectives simultaneously
Detail oriented, organized, and self‐motivated
Additional Qualifications (Preferred)
3+ years as a quality inspector or technician
3+ years in an aerospace manufacturing facility
3+ years in inspection duties, including FAI's, GD&T;, and blueprint interpretation
Proficiency with Microsoft Office products
Effective communication skills
Preferred detail orientation
Any combination of education and experience considered
Vision Requirements
Near vision: meets Orthorater 8 (95% or Jaeger #2 at 12 inches)
Far vision: meets Orthorater 4 (76%) or Snellen Chart *****
Color perception: 6 of 9 Orthorater plates US or international citizenship or permanent residence status required depending on work location
Working Conditions
Productivity: perform work efficiently, effectively, and timely with minimal direction
Mobility: perform light lifting, prolonged sitting, occasional standing, walking (approx. 1–2 miles), reaching, climbing, and balance; drive long distances to suppliers as needed; lift up to 20 pounds
Vision: sufficient to read documents, computer screens, and observe others; includes close, distance, color, peripheral, and focus adjustment
Environment: typical office conditions with quality management, SMS, and external customers; moderate to high noise levels
Other factors: Monday–Friday 8:00 a.m.–5:00 p.m.; occasional extended hours and weekend overtime
#J-*****-Ljbffr

📌 Aerospace Harnessing Source Inspector With Ipc620 (Ciudad Juárez)
🏢 Trigo ADR Americas
📍 Ciudad Juárez