Must have IPC620 Experience*
The Source Inspector (SI) is responsible for performing inspection operations of in‑process or completed hardware, including dimensional and visual inspection. Source inspection may include reviewing all paperwork related to the product, final inspection, receiving inspection, outside processing, and assembly.
The SI verifies FAI’s against AS9102 for accuracy and completeness, uses hand tools and gaging techniques, and interprets B/P and GD&T.; Inspectures occur at end‑customer suppliers’ locations, requiring travel.

Job Responsibilities

Dimensional inspection of aerospace machined components
Perform FAI’s – AS9102
Use hand measurement tools
Apply knowledge of CMM inspection process
Utilize GD&T; (ASME Y14.5) and blueprint interpretation
Conduct final and receiving inspections (dimensional, visual, surface finish, and assembly)
Read, interpret, and apply quality policies, procedures, and documents
Process warehouse materials
Follow established guidelines and procedures
Support corrective actions and root‑cause identification

Perform additional duties as assigned

Required Skills

Experience with dimensional inspection of aerospace machined components
Experience conducting FAI’s – AS9102
Proficient with hand measurement gages and conventional inspection techniques
Knowledge of GD&T; and blueprint interpretation
MS Outlook and Excel proficiency

Valid driver’s license and auto insurance

Additional Desired Skills

Practical experience with quality inspection tools and equipment

Experience in RCCA and problem solving

General Requirements

Ability to handle complex situations and solve problems
Grace under pressure to meet deadlines
Technical and business information analysis




Strong teamwork and communication (verbal and written, including telephone and email)
Ability to remain seated for up to 5 hours
Fluent in English (reading and writing)
Professionalism, integrity, and exceptional attention to detail
Independent decision‑making, analytical skills, and professional judgment
Interpersonal, written, and verbal communication excellence
Ability to manage several objectives simultaneously

Detail oriented, organized, and self‑motivated

Additional Qualifications (Preferred)

3+ years as a quality inspector or technician
3+ years in an aerospace manufacturing facility
3+ years in inspection duties, including FAI’s, GD&T;, and blueprint interpretation
Proficiency with Microsoft Office products
Effective communication skills
Preferred detail orientation

Any combination of education and experience considered

Vision Requirements

Near vision: meets Orthorater 8 (95% or Jaeger #2 at 12 inches)
Far vision: meets Orthorater 4 (76%) or Snellen Chart 20/50

Color perception: 6 of 9 Orthorater plates US or international citizenship or permanent residence status required depending on work location

Working Conditions

Productivity: perform work efficiently, effectively, and timely with minimal direction
Mobility: perform light lifting, prolonged sitting, occasional standing, walking (approx. 1–2 miles), reaching, climbing, and balance; drive long distances to suppliers as needed; lift up to 20 pounds
Vision: sufficient to read documents, computer screens, and observe others; includes close, distance, color, peripheral, and focus adjustment
Environment: typical office conditions with quality management, SMS, and external customers; moderate to high noise levels

Other factors: Monday–Friday 8:00 a.m.–5:00 p.m.; occasional extended hours and weekend overtime

#J-18808-Ljbffr

📌 Aerospace Harnessing Source Inspector with (Ciudad Juárez)
🏢 Trigo ADR Americas
📍 Ciudad Juárez