Primary Function of Position:
Ensure Equipment, Fixture and Toolings are calibrated before their due date, according
to current DOP to assure any Equipment, Fixture or Tooling are available for
manufacturing or inspection of any accessories or products manufactured on the site.
Executes Preventive Maintenance on time and according to SAP and/or Agile system.
Support on Unplanned Maintenance on timely manner and escalate to Engineering any
repair not covered by PMC documentation or MPI. Reports any equipment or fixture with
low productivity to be evaluated or fixed.
Roles & Responsibilities:
• Safety: Follows GMPs and wears safety equipment to perform his/her endeavors
• Participates on Safety commission when required and/or safety training
• Utilize the correct tooling and equipment according to process or PMC requirement,
reporting any condition of wear off or damaged tooling or equipment
• Escalates any safety issues with supervisor or manager
• Follows 5S methodology on his areas
• Reports any safety device on equipment that is fault or is suspicious of been
damaged
• Quality: Performs PM or Calibration before it expires (due date)
and records it’s results on SAP
• Utilize raw materials (when required) to check equipment, fixture or tooling
performance
• Follow up / fulfil EE’s to be loaded into SAP system after PM or Calibration during
unplanned PM or Calibration
• Document and execute LOTO process during OOT events
• Records Asset on SAP and label it, for any EFT after PM or Calibration is performed
• Records on Quality Notifications that require an EE describing problem and
verification results
• Performs and records PM to equipment, fixture or tooling on any top level EFT and
peripheral assets of such EFT
• Efficiency: Provide support to external calibration services or suppliers explaining
requirements or issues with EFTs under service or calibration
• Requires ECOs to Engineering Department or QO Engineer to update or modify
any PMC document that not comply current PMC activities or equipment use
• Performs installation, diagnostic, repair and maintenance to process equipment,
tooling or fixtures that procedures indicate it require
• Update files with daily activities
• Lead or participates on Continuous Improvement projects, kaizen or just do it events
• Creates purchasing request (PR’s) for spare parts
• Escalates excessive consumption of spare parts
• Cost: Sustain and maintain measurement equipment and tooling under his/her
responsibility or ISI Property
• Calculate spare parts over consumption due to uptime improvements or production
incremental in number of cycles per equipment or more production lines
• People: Study and records all assigned curriculum by ISU (Intuitive Surgical
University)
• Creates self evaluation for CIP and MERIT Follows ISI Politic, Rules and code of
conduct
• Provide support to production and/or Engineering during equipment and/or process
validation
• Productivity: Review and complete PM to EFT (Equipment,
Fixture or Tool) before it’s due date in SAP Realize PM or Calibration following EFT
documentation in Agile
• Supports unplanned PM documenting on EE
• Comply with PM’s and calibrations required on daily bases and defined cycle time
• Self-sufficient on knowledge according to Table 1 for